MP40 blinking red

[fio1022]

I have a mp40 since Nov. and love it.I decided to add a second and was excited to have the two paired together.So I have everything set up nice and go the set up master slave.I clear memory on both.I go to next step and original driver starts blinking red.Runs for a few seconds and stops.I repeat sevreal times and same thing.unplugged several times and also Removed wet side and found nothing wrong.
Is there a complete reset?

[EcoTech Marine]

http://ecotechmarine.com/faq/troubleshooting/my-pumps-driver-is-blinking-red-what-should-i-do/

[fio1022]

I tried that several times.NG
Maybe I missed something.I'll try again later.
If not I'll call in the morning

[fio1022]

I tried that several times.NG
Maybe I missed something.I'll try again later.
If not I'll call in the morning

[mapleredta]

Mine did the same. I believe it got wet, I had to send it in for a new board.

[fio1022]

I did the reset wrong.
Finally got everything in sync.