mcallahan
02/01/2011, 10:46 PM
I'm trying to update my EcoSmart firmware to 2.1 from 1.6
I follow the instructions in the WxM manual, the download gets completed, then the Apex says "Begin pump firmware update".
After 10 mins, the Apex still says "Pumps Updated:0"
I think something is happening tho as both my attached Ecosmarts switch into reef crest mode, an mimic each other (go into sync mode)
However, after 10 minutes +, the Apex still says 0 pumps updated.
How long should this process take?
I follow the instructions in the WxM manual, the download gets completed, then the Apex says "Begin pump firmware update".
After 10 mins, the Apex still says "Pumps Updated:0"
I think something is happening tho as both my attached Ecosmarts switch into reef crest mode, an mimic each other (go into sync mode)
However, after 10 minutes +, the Apex still says 0 pumps updated.
How long should this process take?