PDA

View Full Version : 6025 rattling


sondaar
02/17/2011, 12:52 PM
I have a 6025 that is about 1.5 years oldhas been rattling quiet a bit and then just stops spinning. Took everything apart and it seems that the drive unit is really lose inside motor housing. I took my 6045 apart to compare and it is a whole lot tighter fit than the 6025. It shouldnt be that lose should it?

Thanks
Mike

sondaar
02/17/2011, 01:10 PM
The 6045 also has a pin that the drive unit slides down on......6025 has no pin.

rvitko
02/17/2011, 01:34 PM
They both should have a pin, if the pump was made before June 2007, the pin was a lower grade metal and could break, a piece would be in the base of the pump, the rest would be inside the drive unit. After June 2007 production the most likely culprit is that at some point Calcium cemented the propeller to the pin and if the propeller is forcefully removed the pin pulls out with it, usually in this case it can be reinstalled but you have to first remove it from the drive unit.

sondaar
02/17/2011, 01:51 PM
OK the pin is not here as I can see all the way through the drive unit. Also there is nothing inside the pump except a small round nipple at the very bottom center. Do I need a new drive unit and pin or just the pin? Just let me know how much and the payment info.

Thanks
Mike

rvitko
02/17/2011, 03:59 PM
The pin/shaft is not available any way except as part of the motor, on assembly it is pressed in to the motor with a hydraulic press. If you can send it in with a receipt showing it was bought less than 2 years ago we will replace it under warranty, otherwise I will repair it for a very fair price.


Tunze USA
305 Victor St
Austin, TX 78753

sondaar
02/17/2011, 04:46 PM
Thanks Roger, it'll be in the mail tomorrow. The only receipt I have is from my acct. at Marine Depot so just printed that off for you.

Mike

rvitko
02/18/2011, 10:08 AM
That will be fine, I don't need an original receipt, just some proof of date of purchase.

sondaar
02/25/2011, 12:33 PM
Just a quik check to make sure you received the 6025.

rvitko
02/25/2011, 03:30 PM
Yes, it is repaired and going back today.

sondaar
03/03/2011, 03:46 PM
Do you have any way to see where it is? It hasn't showed up yet.

rvitko
03/03/2011, 03:51 PM
UPS shows it was left on your front door on Tuesday.

sondaar
03/03/2011, 04:37 PM
I'll call you.