PDA

View Full Version : How To Properly Replace A Blown Power Unit


szhttm
04/28/2011, 12:08 PM
Hello;

I hope you can assist me...I had an Aquatronica Power Unit (ACQ013-USA) blow on me and I recently ordered a replacement. It was about 4 to 5 years old. Not sure what caused the issue, but we are ready to replace it.

I have three of them installed in the aquarium system (210g reef). The one affected was the first in the series.

How can I properly install the replacement unit so that I can then reload all the settings and have the new become the first one in the series of 3 power units?

I do have the USB/PC interface and I have my last saved set of settings saved on the PC.

I look forward to your response.


Thank you!!!;
:thumbsup: