PDA

View Full Version : EB8 and random noise on the amp sensor?


ianjirka
05/04/2011, 01:33 AM
I have 3 EB8s -- one of them randomly drifts quite a bit, between .1 and .6amps.

The tank is still being prepared, so that graph is with everything shut off. When I have it running, it shows the increased draw (+noise), so it's not completely broken. The other two EB8's are rock-steady when reporting draw.

What is the best way to troubleshoot this?

Thanks much,

-Ian

swearint
05/04/2011, 07:59 AM
Try recalibrating it. There is a section in the New Users Guide stickied at the top of the forum.

Todd

ianjirka
05/05/2011, 07:57 PM
Try recalibrating it. There is a section in the New Users Guide stickied at the top of the forum.

Todd

Well, that seems to have done the trick. I was worried because it was drifting all over the place -- but since the reset, solid zero. Good stuff, thanks!

-Ian