PDA

View Full Version : updated Apex firmware failure ?


Flynnstone
05/29/2011, 09:41 AM
i just updated my Apex firmware to the 4.05-4B11, through a direct connection. ( non-wireless)
i now have the addition profiles and the misc. setup.
all of my module have the updated firmware and display "ok"
since the upgrade i do not see a third channel for the VDM Royal blues. i have power cycled the VDM and the Apex unit with no change.
my display unit is also no longer functioning with no change when power cycling.
any suggestions ???????

kenargo
05/30/2011, 10:56 AM
The new profiles (32 in total) are part of the release...

You must update the VDM firmware using the modules screen and then go into module setup and set the AI type to SOL, then a 3rd channel will appear on the VDM.

The blank display, if you haven't tried it perform a modules update on display, try that; you may need to disconnect the display module for a moment after the update to get it back.

Flynnstone
05/30/2011, 11:53 AM
problem fixed on the VDM. thanks for the help. i had to borrow a display to set it up. i will call Curt Tues and see what i need to do with my dead one.
thanks again