View Full Version : Module issue on Apex Lite.....
mitchjstein
07/06/2011, 06:58 AM
Help,
I have added qty 2 PM1 units so I could have ORP and PH My Apex lite only sees 1 PM1 unit, how do I get it to add the second PM1 unit?
Thanks in advance,
Mitch
aquamanic
07/06/2011, 09:37 AM
Are you looking at the Module Setup screen? It only shows a single PM1 there?
mitchjstein
07/06/2011, 11:39 AM
Alan,
Yes the module setup screen only shows one of the 2 modules.
aquamanic
07/06/2011, 04:01 PM
What I would do is:
1. Save my program and configurations
2. From the Misc Setup page (if you're on 4.1), select 'Initialize Memory' and select 'Aquabus Devices'. If you're on a release prior to 4.1, do it through the display module "System - Init Memory - Init Aquabus Dev".
See if it discovers it that way.
RussM
07/06/2011, 04:04 PM
Is the Status LED lit on the missing PM1?
scsuboy18
07/07/2011, 09:52 AM
I have noticed that any type of memory initializing sucks on the web interface and doesn't work...at least for me using a mac and safari. Using the display, it does the job in a jiffy.
mitchjstein
07/07/2011, 12:00 PM
Is the Status LED lit on the missing PM1?
Russ,
Yes the status light is lit.
RussM
07/07/2011, 12:24 PM
Ok so it has power. Did you try aquamanic's suggestion?
mitchjstein
07/11/2011, 08:59 AM
Ok so it has power. Did you try aquamanic's suggestion?
Russ and Aquamanic,
Yes I tried this: 'Initialize Memory' and select 'Aquabus Devices'
and it did not work. What eventually did work was to try different combinations and re-initialize the aquabus.... I finally have all modules listed but I am afraid that they might not stay in memory...... It is supposed to be a plug and detect interface as far as I can tell, but it definitely is not!
Is this a know issue?
vBulletin® v3.8.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.