soverjas
09/05/2011, 09:23 PM
I am stumped on the drain size of my pluming. Anyone have any experience heat bending PVC. Check out this short video I did then see if there is any suggestions you can make for me. I just watched a video where I can heat up sand and bend into place. That might work. I suck at plumbing. Half tempted to see if I can hire a plumber to come out and hook my tank up! I would prefer to have the system hard plumbed to avoid a disaster versus using barbed fittings and clamps.
http://www.youtube.com/watch?v=_GB9CmBtq-M&feature=channel_video_title
http://www.youtube.com/watch?v=_GB9CmBtq-M&feature=channel_video_title