PDA

View Full Version : MPwES10 question

yellowbellied
09/20/2011, 07:00 PM
Before I buy it, can someone answer this. I have a 60 gallon acrylic. The water level is around 1.5 inch from the top. Will the waves over flow the tank?

thanks.
tkeracer619
09/20/2011, 07:15 PM
Doubtful. They are adjustable so they can be turned down.

What are your goals? If this is going to be used by itself I would probably go with a single mp40. The mp10 is also limited to 3/8 thick material.
tkeracer619
09/20/2011, 07:16 PM
Doubtful. They are adjustable so they can be turned down.

What are your goals? If this is going to be used by itself I would probably go with a single mp40. The mp10 is also limited to 3/8 thick material.
nemosworld
09/20/2011, 07:27 PM
you do not have to use the wave function, and if you do, like said above, it can be adjusted to not do that.
Eurobeaner
09/20/2011, 07:44 PM
i think some people think vortech's ONLY produce the wave motion and nothing else. thats just ONE function of MANY that are FULLY adjustable flow wise
Eurobeaner
09/20/2011, 07:53 PM
i think some people think vortech's ONLY produce the wave motion and nothing else. thats just ONE function of MANY that are FULLY adjustable flow wise
yellowbellied
09/20/2011, 11:41 PM
I saw videos online and thinking "Whooaaa!"
bellis31
09/20/2011, 11:45 PM
I use Reef Crest Mode.... no wave just random flow...
Blayz77
09/21/2011, 12:14 AM
i have a 50g cube 24x24x24 and my water level is id say 1/2 to 3/4 inch max from top of tank. with 2 mp10 es even on max power the waves will not spill over. ymmv
chrishayes
09/21/2011, 06:42 AM
I second that one mp10 will not be enough in your tank. I have a 45 cube and one of these. About to buy a 40 today and sell the 10. Let me know if you are in the market. Good luck