Dimissions Question

[Kris71]

Hello everyone
I am building a stand for a 90 Gallon reef tank with cornor overflow. My question is does anyone know the location of the drilled holes? I just want to make sure I have room with the corner post of the stand

Thanks for all your advice!!!

[thegrun]

That is going to vary with each tank manufacturer. I like to leave a single rather large opening at the bottom of the overflow rather than cut individual holes. If you ever have a leak at your bulkhead, you will be thanking yourself that you have a little more room.

[HowieB]

Every tank is different. Wait until you have the tank, then cut the opening in the stand to fit.

[Kris71]

Thanks!!!
I guess the real question I have is I used 4x4s for the legs on the frame Nd just want to know if the 4x4 in one corner will interfere with the overflow. I was planning on cutting out enough space on the shelf for the plumbing. I wanted to buy the tank first then build but I am told I don't have agreattrack record of finishing DIY stuff the wife says lol so she said no tank till the stand is presentable for the house. I am sure others here this :)
So I just wanted to make sure I am not rebuilding the frame again