switching from two part to reactor ?'s

[tmc1313]

I'm switching over from two part dosing to a GEO reactor. My question is, if I'm dosing 150ml per day of part A and B each in equal amounts, what should my effluent rate be from the reactor to be able to match my dosing rate?

[Randy Holmes-Farley]

That would depend on the alkalinity in the effluent.

It is probably easiest to pick a flow rate that is typical for that reactor, and adjust the CO2 until the tank alkalinity is stable where you want it. :)

[tmc1313]

Thanks Randy, another question I have is about a feed pump for the reactor. I did buy the MJ1200 for the GEO that was recommeded, but I have read some people use a dedicated peristaltic pump that is designed to run 24/7. Any thoughts on this? If the peristaltic pump is the way to go, then who makes a good one that is designed for continuous use?

[Randy Holmes-Farley]

Sorry, i don't have any useful advice on pumps for the reactor. :)