reefstricken
03/30/2012, 02:16 PM
I've not quite made up my mind on the closed loop orientation.
I do know that I would like to drill only one side of the tank, all the others are against the wall anyhow.
The tank is only 18" wide, so i'm planning on 3 x 1" bulkheads for the overflow. I have been debating on an overflow at each end, but I may be moving soon and have dreams of this being viewable from both ends, or a peninsula.
I have available 2 x iwaki 55's and 1 reeflo dart. I'm thinking of either 2 x 1.5" intakes to the iwakis, with outputs opposite corner on the far side, so it's effectively pulling across the tank, then it would switch to the opposite pull, perhaps 2 hours on for each?
The dart would be run with a 2" intake and 2 outlets on the far side.
alternatively I could run outputs all along the top.
As flow needs grow, I will likely add vortechs.
Thoughts?
http://www.blakevosburgh.com/coral/closedloop.png
I do know that I would like to drill only one side of the tank, all the others are against the wall anyhow.
The tank is only 18" wide, so i'm planning on 3 x 1" bulkheads for the overflow. I have been debating on an overflow at each end, but I may be moving soon and have dreams of this being viewable from both ends, or a peninsula.
I have available 2 x iwaki 55's and 1 reeflo dart. I'm thinking of either 2 x 1.5" intakes to the iwakis, with outputs opposite corner on the far side, so it's effectively pulling across the tank, then it would switch to the opposite pull, perhaps 2 hours on for each?
The dart would be run with a 2" intake and 2 outlets on the far side.
alternatively I could run outputs all along the top.
As flow needs grow, I will likely add vortechs.
Thoughts?
http://www.blakevosburgh.com/coral/closedloop.png