MP 40 sliding down

[75pxatr]

My mp 40 gradually works its way down the glass. I have replaced the wet side and still does the same thing. I tried changing to a higher glass thickness setting but still no luck.

Anyone else have this problem and solved it?

[ghostman]

What thickness glass do you have? Try adjusting the pin spacer to a higher thickness, or removing the rubber pad. Also are you using the square sticky cord mounts? They not only work for holding the the pump I. Case it falls off, but they hold them in place.

[75pxatr]

glass is 1/2 inch thick. I adjusted the pin spacer to 5/8 but still moves down.

[ghostman]

Try using a thicker pin spacing and see if the results are better. My glass is half inch, but I uses size thicker on my spacer. They are strong magnets, and should hold well.

[tkeracer619]

Contact Ecotech.

Also, do not set the pin spacer incorrectly. It is designed so that the force is not too strong on the bearings. Setting it thicker then it really is will wear the wet and dry side much faster then when set properly.

[dadnjesse]

do you have the rubber gasket between the glass and the dryside