View Full Version : Tunze help please?
adam1980
06/05/2012, 01:56 PM
Hey guys a bought a used tunze 6105 a little while ago of r/c it worked great for about 2 months. Now it only seems to run for about 1-3 minutes and the fan just stops. I took the Magnet out and cleaned it and that is all it will do. Does anyone know if maybe the magnets sometimes go bad in the tunzes? Or anyone have any ideas? thanks!
sbeason
06/05/2012, 02:50 PM
You might want to post this in the TUNZE forum to get a quicker response. I am assuming you are not running it on a tunze controller?
Steve
adam1980
06/05/2012, 02:53 PM
Thanks i will do that, and yes i am running it on a controller.
James77
06/05/2012, 03:30 PM
Do post in the Tunze forum, Roger will help.
But, does the magnet( the drive assembly) spin freely on the shaft when you spin it in your fingers?
The best way to clean them is a soak in 50/50 water vinegar for an hour or 2.
adam1980
06/06/2012, 06:01 AM
I have not tryed doing that James, will do tonight when i get home.
Jeff_NJ
06/06/2012, 07:27 AM
Good luck! I just bought a 6105 and the motor case must have had a tiny little hole in it that allowed water to enter. The powerhead exhibited similar behavior - then it went boom! Literally.
vBulletin® v3.8.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.