JinxXx0085
07/08/2012, 03:54 PM
It have been few years and now I finally got my RO/DI hooked back up again to be used for my FW planted tank. Sorry no reef yet :-P
My unit has dual TDS meters and a booster pump hooked up. Well water gives me very low pressure - around 30 psi. With booster pump, I have it set for ~70 psi :)
I just have replaced my filters but not the resin and got the following readings:
Well water TDS: 152
Between filters and resin (carbon): 157
Water out from resin: 0
So, my question is what is going on? When will the water coming out from brand new filters will start lowering compared to input from well water??
I've attached a picture of my set up... It is as it is currently during testing phase before I'll add in coil in the tubing to warm water up prior going into the unit. If any other suggestions, do tell! LOL.
http://i55.photobucket.com/albums/g131/JinxXx0085/MISC/2012-07-08_09-47-54_432.jpg
My unit has dual TDS meters and a booster pump hooked up. Well water gives me very low pressure - around 30 psi. With booster pump, I have it set for ~70 psi :)
I just have replaced my filters but not the resin and got the following readings:
Well water TDS: 152
Between filters and resin (carbon): 157
Water out from resin: 0
So, my question is what is going on? When will the water coming out from brand new filters will start lowering compared to input from well water??
I've attached a picture of my set up... It is as it is currently during testing phase before I'll add in coil in the tubing to warm water up prior going into the unit. If any other suggestions, do tell! LOL.
http://i55.photobucket.com/albums/g131/JinxXx0085/MISC/2012-07-08_09-47-54_432.jpg