MX175
07/09/2012, 08:15 PM
Anyone have a sample Apex code snippets to maintain salinity levels?
How Dialyseas does it:
If conductivity reading is low, a doser is powered on for a short amount of time. The doser pulls concentrated salt water from a container and adds it to the sump. Easy stuff if done slowly and in small increments.
If conductivity reading is high, the Dialyseas does nothing other than continues to remove a small amount of water from the system on its regular daily schedule. A standard Auto Topoff adds regular RO water back to the sump and the salinity gradually goes back into check. Again, easy stuff.
Thoughts? Experiences?
How Dialyseas does it:
If conductivity reading is low, a doser is powered on for a short amount of time. The doser pulls concentrated salt water from a container and adds it to the sump. Easy stuff if done slowly and in small increments.
If conductivity reading is high, the Dialyseas does nothing other than continues to remove a small amount of water from the system on its regular daily schedule. A standard Auto Topoff adds regular RO water back to the sump and the salinity gradually goes back into check. Again, easy stuff.
Thoughts? Experiences?