vbsaltydog
08/19/2012, 10:05 PM
I have a Tunze 6100 running a pump profile of
Synchronize: disabled
Divide by 10: disabled
Init: 0
On: 15
Off: 15
Min: 30
Max: 60
If I understand correctly, a pump profile is just an OSC command with ramping added so my profile should be equivalent to:
OSC 0/:15/:15
but when the pump is on for 15 seconds, it should be ramping from 30% to 60% over the 15 seconds.
This is not happening. What is happening is a repetitive short ramping, over and over for the 15 seconds before resting for 15 seconds and repeating.
So basically it ramps from unknown percent to unknown percent roughly 15 times in the 15 second "ON period", rests for 15 seconds, and repeats.
Any help is appreciated.
Synchronize: disabled
Divide by 10: disabled
Init: 0
On: 15
Off: 15
Min: 30
Max: 60
If I understand correctly, a pump profile is just an OSC command with ramping added so my profile should be equivalent to:
OSC 0/:15/:15
but when the pump is on for 15 seconds, it should be ramping from 30% to 60% over the 15 seconds.
This is not happening. What is happening is a repetitive short ramping, over and over for the 15 seconds before resting for 15 seconds and repeating.
So basically it ramps from unknown percent to unknown percent roughly 15 times in the 15 second "ON period", rests for 15 seconds, and repeats.
Any help is appreciated.