jctse
08/20/2012, 11:27 AM
If you have experience with diy LED's can you give me some advice on how to find a probable short?
40 Leds on 2 drivers (LPF-60D-48 one for the blue and the other for the white), each controlling 2 strings of 10. 4 fuses.
When I try it the 20 white work fine but one of the blue strings of 10 does not light.
Before turning it on (and after) I tested from wire to wire each Led-they still appear to be good. The tester is basically 2 AA batteries. I have an older multimeter that can test Amps, Volts, and contunuity but not many other bells and whistles. I switched the fuses around as well thinking it might be a bad fuse.
I have a picture of the led and heatsink, multimeter, and tester.
With what I have can I test for a short or do I need a better multimeter?
Many thanks....
http://i46.*******.com/2ic9kc5.jpg
http://i47.*******.com/2h56tky.jpg
http://i50.*******.com/2lnhm9y.jpg
http://i48.*******.com/23uo0ll.jpg
40 Leds on 2 drivers (LPF-60D-48 one for the blue and the other for the white), each controlling 2 strings of 10. 4 fuses.
When I try it the 20 white work fine but one of the blue strings of 10 does not light.
Before turning it on (and after) I tested from wire to wire each Led-they still appear to be good. The tester is basically 2 AA batteries. I have an older multimeter that can test Amps, Volts, and contunuity but not many other bells and whistles. I switched the fuses around as well thinking it might be a bad fuse.
I have a picture of the led and heatsink, multimeter, and tester.
With what I have can I test for a short or do I need a better multimeter?
Many thanks....
http://i46.*******.com/2ic9kc5.jpg
http://i47.*******.com/2h56tky.jpg
http://i50.*******.com/2lnhm9y.jpg
http://i48.*******.com/23uo0ll.jpg