Replace LED drivers

[ejbowers948]

I have a pre-made LED LIght( love it). I want to control the brightness with my neptune VDM but the drivers are not adjustable. I would love to switch them out with a driver that is. It currently has a driver that has the following on it (100v 20v 50/60hz 55-100/v 450ma) , two of these drivers run 55 leds. Does any one know what I can swap it off with that has a 1-10v adjustment.

Sent from my iPad using Tapatalk HD

http://img.tapatalk.com/d/12/11/12/uduby6u2.jpg
http://img.tapatalk.com/d/12/11/12/uheda5ut.jpg

[garryclarkfl]

Might be more trouble than it's worth, but if you must depending on the voltage of each string I believe you can get a meanwell or inventronics that would fit the Bill.

[RussM]

You might be better off asking this question in the DIY forum.