PDA

View Full Version : apex profile pump time


Giovanni
12/16/2012, 01:28 PM
I am trying to get my left pumps to run at 100% for 5 minutes (300sec) then off for 5 minutes and the right pump to alternate. Tried with a profile but It seems the profile with the pump setting will only accept 100 sec. What can I do?

RussM
12/16/2012, 02:17 PM
What kind of pumps?

Giovanni
12/16/2012, 02:44 PM
Tunze. But does it matter?

Giovanni
12/17/2012, 12:09 PM
Anyone?

swearint
12/17/2012, 01:18 PM
If you don't need to vary the intensity, just use the OSC command.

[Left]
OSC 0/5:00/5:00 Then ON

[Right]
Set ON
If Outlet Left = ON Then OFF

Todd

Giovanni
12/17/2012, 02:50 PM
If you don't need to vary the intensity, just use the OSC command.

[Left]
OSC 0/5:00/5:00 Then ON

[Right]
Set ON
If Outlet Left = ON Then OFF

Todd

I just want to do that for a few hrs a day and have programming with other profiles. Will that "if outlet left" cause the right pump to run when i don't want it to?

swearint
12/17/2012, 04:20 PM
In that case, the OSC would be the default/starting behavior and then use other conditions to set the desired profile.

[Left]
OSC 0/5:00/5:00 Then ON
If Time .... Then PFx
If Time .... Then PFy

[Right]
OSC 5:00/5:00/0 Then ON
If Time .... Then PFx
If Time .... Then PFy

Notice the difference in the OSC parameters between the two. The first parameter sets the offset.


Todd

Giovanni
12/17/2012, 04:22 PM
Great. Thanks for the help that is what I needed.