bsnile23
12/19/2012, 12:33 AM
So I did the ever popular bearing replacement on one of my four MP10's.
I did run into a major problem. I stripped two of the three screws that hold the motor housing together. I did manage to get them out and replace the bearings. I need 2 more of these screws to put it back together.
M2.5 x 40mm machine screw. Flat head Phillips.
I've been to all the specialty screw shops around. Also the hobby shops. Spent a day on Google and only found 1 place that had it. It was in the UK.
I hate to have to buy a new dryside or send this in repair because I cant purchase 2 screws.
Can someone here point me in the right direction?
I contacted ecotech and they said they don't have any or no where to get any.
Brian
Sent from my ADR6400L using Tapatalk 2
I did run into a major problem. I stripped two of the three screws that hold the motor housing together. I did manage to get them out and replace the bearings. I need 2 more of these screws to put it back together.
M2.5 x 40mm machine screw. Flat head Phillips.
I've been to all the specialty screw shops around. Also the hobby shops. Spent a day on Google and only found 1 place that had it. It was in the UK.
I hate to have to buy a new dryside or send this in repair because I cant purchase 2 screws.
Can someone here point me in the right direction?
I contacted ecotech and they said they don't have any or no where to get any.
Brian
Sent from my ADR6400L using Tapatalk 2