Anyone do a Biocube 29 stand assembly?

[FlyPenFly]

So it seems the two side panels really bear all the load with the rear panel not really being a structural piece.

A problem I had though was that I ended up with 2 extra screws in shiny metal. I used all 8 of the big black hex screws. Four for the top, four for the bottom. In the picture it seems like there's supposed to be a rear spot for the two unfinished shiny screws but there's no precut hole and I can't figure out where else it would go?

I have the version with 2 doors, no glass.

Any ideas?

[potterjon]

I am not saying this is the case but wit a lot of products they throw a couple extra screws in just in case you lose a few.

[biocube14g]

+1... Most throw in a few extra parts/pieces so they don't have to deal with shipping new parts/pieces if the customer had any lost/missing pieces.

[biocube14g]

On the other hand, Could those be the screws for the hinges to adjust the open/close distance of the doors?

[Biocubehqi]

They are extra screws. No worries...