magnus
08/10/2003, 09:00 AM
I have used the Osmolator 5024 sinca 18 months and are very pleased with it.
However, after I did change the pump 5024.04 since the old one did burn, the new pump is creating a lot of microbubbles when the waterlevel is just enough high to not start the top off pump. I beleave the pump is sucking in air through the blue sponge. This is also creating a lot of disturbing noise. If I increase the water level manually the bubbles and noise goes away, but then the purpose of the osmolator is to top off automatically. I suspect this was also the cause for the old pump to burn.
I there a way to adjust or tune the osmolator to avoid this ?
However, after I did change the pump 5024.04 since the old one did burn, the new pump is creating a lot of microbubbles when the waterlevel is just enough high to not start the top off pump. I beleave the pump is sucking in air through the blue sponge. This is also creating a lot of disturbing noise. If I increase the water level manually the bubbles and noise goes away, but then the purpose of the osmolator is to top off automatically. I suspect this was also the cause for the old pump to burn.
I there a way to adjust or tune the osmolator to avoid this ?