dknydiep
03/04/2013, 12:12 PM
Hey guys,
I've never had a RODI before but I'm picking up a 120g tonight, so I bought a used Spectrapure unit yesterday to prep for today. After running it for a bit, it came out to 009 TDS. I then switched the DI and it ran at 000 for 2-3 hours. I went to check on it during the night, and it was at 130+, and then this morning I checked on it again and it was at 004.
Is this normal, and will this water be ok to use for my new setup?
Also, on a side note, will the BRS sediment and carbon replacements fit this unit? (10 inch cartridges).
Thanks!
J
I've never had a RODI before but I'm picking up a 120g tonight, so I bought a used Spectrapure unit yesterday to prep for today. After running it for a bit, it came out to 009 TDS. I then switched the DI and it ran at 000 for 2-3 hours. I went to check on it during the night, and it was at 130+, and then this morning I checked on it again and it was at 004.
Is this normal, and will this water be ok to use for my new setup?
Also, on a side note, will the BRS sediment and carbon replacements fit this unit? (10 inch cartridges).
Thanks!
J