PDA

View Full Version : SW update from 8.0 to 9.0


clelis76
03/09/2013, 08:42 AM
Dear all,

i am trying to update though the aquatronica update software installed on my pc from the SW V8.0 to V9.0 but i get a message that the only available software is V8.0 . I have noticed at the aquatronica website that there is a release of V9.0 .Does any one faced this problem?

Thanx

yettihead
03/09/2013, 09:07 AM
You have to download the updated software from the website. Aquatronica shut down the update of the software from within the software a while back. So once you download the updated software, it will let you update your components.

Chad

clelis76
03/09/2013, 02:27 PM
thanx i'll try that

clelis76
03/19/2013, 06:49 AM
I did as you suggested and i manage to update the SW to V 9.0 and ethernet version to 5.0 .I have a question though, when i am accessing the ethernet module to view everything from pc i noticed that on the top of the page says ethernet interface version 3.1 .Is this a problem ? should i worry about it?

yettihead
03/19/2013, 07:48 AM
I will have to look at mine when I get a chance.

Sent from my PG86100 using Tapatalk 2

AQT
03/20/2013, 07:14 AM
well clelis76 it is correct no problem! It is that the version 5.0 is the updat of the firmware and what you see in the page from the PC is the version of the page (not of the firmware) and it is correct to see version 3.1... so all ok!! ;-)
Take care
Davide

clelis76
03/21/2013, 02:21 AM
thanx Davide