PDA

View Full Version : AI not following timer peramiters after move


Vegas RN
06/27/2013, 10:36 AM
Just wondering if anyone has had the same problem. Moved the tank to a new place and didnt change anything but now the lights don't follow any set peramiters. They turn off early. Start early sometimes and on time the next day. Can't figure it out. Anyone have any suggestions?

L8ndeb
06/27/2013, 10:48 AM
Could you please post your programming?

Vegas RN
06/27/2013, 11:18 AM
At work will post later. Thanks. Just weird because everything worked perfectly until I moved the tank

L8ndeb
06/27/2013, 11:36 AM
I have read instances where a move has resulted in Apex programming corruption. Probably a good bet.
Are there any other outlets that have changed?

slief
06/28/2013, 10:14 AM
I would double check your VDM cables and make sure you did plug the fixtures into the wrong VDM ports.

L8ndeb
06/28/2013, 10:47 AM
I would double check your VDM cables and make sure you did plug the fixtures into the wrong VDM ports.

Just as a heads up, the AI fixtures use the serial port on the VDM.

Vegas RN
06/28/2013, 12:19 PM
Thanks for the help everyone I reprogrammed it and its working so far.