tunze 6105's with 7095 controller

[Reefstinger]

Ok so i got 2 6105's and a 7095 controller from another member , hooked them up , tried different settings and the 6105's seem overkill on my 160 gallon, its 5ft long 30 inches wide x 22 inches tall. the lowest setting seems to be too strong. Any suggestions folks?? I tried 1 jeabo wp-40 and a small tunze on the opposite corner of ends and it seemed perfect even with a nice wave. the other day, but these Tunze , i just cannot get them set correctly:wildone:

[Mpfaff77]

Did you get the voltage pins with the pumps? The go into the power supply from 12-24v and would lower the flow drastically if put 12v in.

[Reefstinger]

Did you get the voltage pins with the pumps? The go into the power supply from 12-24v and would lower the flow drastically if put 12v in.


I only have a small white knob on the power supplies that i believe will cut the voltage down. do i need to cut them to 12V

[Mpfaff77]

Oh maybe it is different setup than my 6095s. I would turn then down to 12v if running too much. Or post in tunze section and wait for roger from tunze to respond. He will know what to do. Or email support.

[Reefstinger]

MP , Thanks the White knobs on the inline into power supplies actually calmed everything down, My wave is nice and smooth now. Thanks For your HELP!!