candamo
11/19/2013, 02:27 PM
Hi RCers,
This is my setup for my newly DIY HOB refugium:
http://tampany.com/images/temp/IMG_4404.JPG
http://tampany.com/images/temp/IMG_4405.JPG
http://tampany.com/images/temp/IMG_4406.JPG
Basically, I tried with a MJ 600 pump after a MJ1200 was too strong, and the drainage couldn't keep up with the flow coming into the refugium. I placed the MJ inside of my tank, I even installed a ball valve to reduce water being pumped in (you can see in http://tampany.com/images/temp/IMG_4405.JPG to the right), but at the other end (in pic http://tampany.com/images/temp/IMG_4405.JPG to the left) the drainage is so tiny that can't keep up and the refugium overflows. I also tried building a 1in overflow PVC system (from http://www.youtube.com/watch?v=7DFk4bnIxEg) but the drainage flow is also tiny compare o what's going in.
Any ideas or alternatives?
This is my setup for my newly DIY HOB refugium:
http://tampany.com/images/temp/IMG_4404.JPG
http://tampany.com/images/temp/IMG_4405.JPG
http://tampany.com/images/temp/IMG_4406.JPG
Basically, I tried with a MJ 600 pump after a MJ1200 was too strong, and the drainage couldn't keep up with the flow coming into the refugium. I placed the MJ inside of my tank, I even installed a ball valve to reduce water being pumped in (you can see in http://tampany.com/images/temp/IMG_4405.JPG to the right), but at the other end (in pic http://tampany.com/images/temp/IMG_4405.JPG to the left) the drainage is so tiny that can't keep up and the refugium overflows. I also tried building a 1in overflow PVC system (from http://www.youtube.com/watch?v=7DFk4bnIxEg) but the drainage flow is also tiny compare o what's going in.
Any ideas or alternatives?