2MP40w's and wave in 75g

[thabizness]

I have been playing around with the short pulse wave function in my 75g. I have a MP40 on each side of the tank. I cant seem to get a good wave. My settings are .8 seconds. I have tried sync and anti sync.

I was wondering what other people settings are to produce a wave in a 75g.

[Alex Y EcoTech]

Thabizness,

I would recommend placing the pumps in an area where they can provide unobstructed flow. From there, use anti-sync mode and experiment with speed and pulse until you dial in the exact wave you'd like.

[worm5406]

Make one pump SYNC.

Set the master to Nutrient mode and watch the tank.

Nutrient mode will cycle through the spacing and you will see a wave get created.

Granted you can not see what the spacing is, but you will see that it is possible.

In my 180 I have a wave at .54 and at .56 that disappears quickly... If I could hit .55 it would stay but it only likes even numbers. I can not remember the exact # right now as I am not in front of it. But you get my point.

[thabizness]

I have created a small wave with .7 at 55%. The other one is anti sync at 35%.

[worm5406]

When doing this it is best to have the % set to the same. That way it will support each other when in different modes.

Otherwise it may work against it in the wrong way.

[thabizness]

I tried that when doing both same percent the wave would not generate. Ill try it again tonight tho.

[worm5406]

Set it the the same % and let it set for like a minute or two.

Then adjust it .01 each time and find the sweet spot.