Is this level enough?

[Newms118]

So after setting up my 65 gallon tank I'm still wondering if more improvements should be made to the leveling. Right now here is the tank side to side.
http://img.tapatalk.com/d/14/02/14/eme2e4ug.jpg
http://img.tapatalk.com/d/14/02/14/he9e2aqy.jpg


Now this is front to back (left side)
http://img.tapatalk.com/d/14/02/14/2upebapy.jpghttp://img.tapatalk.com/d/14/02/14/y8ese9y5.jpg

And front to back (right side)
http://img.tapatalk.com/d/14/02/14/gymymugu.jpg
http://img.tapatalk.com/d/14/02/14/9ajagavy.jpg

Here is the diagonals
http://img.tapatalk.com/d/14/02/14/uga9yva3.jpg
Second diagonal
http://img.tapatalk.com/d/14/02/14/ymy6a9a8.jpg

So you can see I'm about 1/16 off front to back, with the tank leaning slightly forward. The amount of off levelness between the front to back left and right sides is about the same so I don't think the tank is twisting.

Is this good enough? I feel like I'm just being neurotic but want to err on the side of caution.

[Newms118]

Btw this is how I'm setting up the levels, since the more accurate blue one is too short to go completely across, I put it on top of a bigger one to get a better reading across the whole tank.
http://img.tapatalk.com/d/14/02/14/de9yvagu.jpg

[Dustyboots]

I'd be more concerned with the stands level. I think you're splitting hairs.

[Newms118]

I don't get that, everything I've read said to pay attention to the tank level. Since I've shimmed the stand I expect it to be more off level than the tank.

When I looked at the stands level from side to side it was perfectly level, like the tank.

When I look at the front to back, the off levelness is more extreme than the tank.
http://img.tapatalk.com/d/14/02/14/ru8e7y4a.jpghttp://img.tapatalk.com/d/
14/02/14/gegyqa5a.jpg

So can I ignore the stand levelness and just focus on the tank?

[Newms118]

Here's that pic that was broken
http://img.tapatalk.com/d/14/02/14/zequjytu.jpg

[Tzwizzle]

I think you are good. A level tank means less stress on the seals. hard to have a level tank without a level stand unless you shim the tank which I personally would not do.

[Cymonous]

Level the tank. Shimming is usually recommended actually. If you leave it not level, it puts more stress on the panes of glass and seams.