How to cover my starphire rimless tank?

[justinky]

Hi, so I have a 82G 1/2 inch thick starphire glass tank. I am trying to cover it with the BRS 1/4 net screen top but I ran into the problem of how am I going to get it to securely sit on my tank. I googled for ideas and came up with the clear tank clips but the biggest I have found was 12mm and my glass is closer to 13mm so that won't work. All ideas much appreciated.

Is there any chance the 12mm clip would work, http://www.amazon.com/Aquarium-Glass-Acrylic-Support-Holder/dp/B00H365CPC/ref=pd_sim_sbs_petsupplies_3?ie=UTF8&refRID=0J8YJA4XX0HRK1DQSD49?

[fijisrfr]

I just used a thin strip of Velcro about one inch long on three sides. Works fine.

[justinky]

That might work, do you think my overflow will cause any problems on setting it up?

http://i.imgur.com/JPT7kGn.jpg

http://i.imgur.com/pkDBKzp.png

[mark54321]

This is what I did, screen fits inside tank and it is held by acrylic tabs glued to frame. Later I modified it and instead two I glued four tabs on all corners. Can't even tell frame is there from a distance.

http://i835.photobucket.com/albums/zz277/markmikina/screentop2_zpsbc1e61f0.jpg
http://i835.photobucket.com/albums/zz277/markmikina/top_zps88759ace.jpg
http://i835.photobucket.com/albums/zz277/markmikina/screentop1_zps382bf93f.jpg
http://i835.photobucket.com/albums/zz277/markmikina/screentop_zps9ebe896b.jpg

[fijisrfr]

That might work, do you think my overflow will cause any problems on setting it up?

http://i.imgur.com/JPT7kGn.jpg

http://i.imgur.com/pkDBKzp.png

Depends, can't tell from the pic, are the durso & return arms above the rim? If so them it may not work. If they are below the rim then it should work. Pics of mine:
http://img.tapatalk.com/d/14/04/19/ugyzy9as.jpghttp://img.tapatalk.com/d/14/04/19/evedyrag.jpgr
http://img.tapatalk.com/d/14/04/19/be3yzasu.jpg