PDA

View Full Version : Return Pump Plumbing


Arc Drafter
04/26/2014, 07:25 AM
Hey everyone, my return pump went out on my 60g yesterday and I am working on building a 220 so I wanted to buy a pump that I could run my 60g for now while I get my 220 going. I was wondering if Automotive Heater Hose would be safe for the aquarium. I am hoping to use it for the inlet side of my external pump.

Usernam Invalid
04/26/2014, 07:28 AM
I wouldn't use any other material beside PVC for fear of chemicals leaching into water

johnike
04/26/2014, 07:32 AM
I wouldn't. Get down to the hardware store and get the clear vinyl tubing.

scott3569
04/26/2014, 07:37 AM
+ one on both comments above!! you want to get something that is at the very least made to drink from...water heater hose is not made to drink from

Arc Drafter
04/26/2014, 07:39 AM
alright you guys sold me thanks for getting back to me

johnike
04/26/2014, 07:55 AM
Don't forget clamps if needed.
;)
:)

Arc Drafter
04/26/2014, 08:54 AM
Don't forget clamps if needed.
;)
:)

Good Call. Luckily I have a few extra here. I was able to get some reinforced Vinyl tubing. The original vinyl tubing I was using was collapsing when the pump was running. I'm sure this will be better. Thanks again everyone.

Arc Drafter
04/26/2014, 09:59 AM
Well I got it plumbed and running. Thanks again everyone.

Arc Drafter
04/28/2014, 08:55 AM
Now my Pan World pump is leaking... Any ideas on how to fix that?

uncleof6
04/28/2014, 02:20 PM
Check the fittings, use a non-hardening thread sealant (not tape) on any threaded joins, and change the seals in the pump head. While your at it, service the motor, per the instructions. The seals, and motor maintenance should be a regular routine on pumps in continuous use. Otherwise, they take a dump on ya. I have pumps still running that I purchased in 1984.

Arc Drafter
04/29/2014, 08:33 AM
Check the fittings, use a non-hardening thread sealant (not tape) on any threaded joins, and change the seals in the pump head. While your at it, service the motor, per the instructions. The seals, and motor maintenance should be a regular routine on pumps in continuous use. Otherwise, they take a dump on ya. I have pumps still running that I purchased in 1984.

Great thanks for the tips.