PDA

View Full Version : Programing a wave function with MP60s


mrx66699
05/04/2014, 02:00 PM
Need some assistance with programing a wave function with 2 MP60s, one at each end of a 96x36x36 ....using apex fusion with wxm.....it seems no matter what the settings visual wave is not present....reefcrest seems like its moving more water ....the system has 8 return outlets facing random points and is powered by 2 reeflow super gold darts running wide open so it has a ton of return flow coming in and has a cost to cost overflow out of the way.....rocks are straight down the middle away from the front and back....pumps are placed just above half way down on the ends and not obstructed by any rockwork

what should the programing be for a 1-2in wave

mrx66699
05/05/2014, 09:02 AM
What....no one knows how to do this...lol

mrx66699
05/05/2014, 03:04 PM
WOW over 24 hr and no response ....So much for the Neptune supposed support .....a simple request here you would think and not one response from a vender LOL

Larz_1
05/05/2014, 03:20 PM
My understanding is that Neptune does not monitor this board.
You might have better luck @ http://www.neptunesystems.com/support/

mrx66699
05/05/2014, 06:24 PM
Ok thanks ....lol

alainb600
05/06/2014, 02:25 AM
Set the master pump at pulse at 100% and set the slave at anti-sync at 100% . Then adjust the pulse time until you get a wave .

Alain