m-six hundred
06/14/2014, 09:18 PM
I have three EB8's and one is reading the amperage incorrectly.
I only have a Reef Octopus DC5500 return pump plugged into it. The pump is rated at 50 watts at full speed. .4-.45amps
The EB8 registers 2.2 amps
I have gone through the telnet power calibration and when all outlets are turned off they register 0 amps.
Another problem is when I start to turn on empty outlets one by one the amperage dray pulls 1 more amp.
So if I have on out on running the return pump the eb8 reads 2.2 then I turn on a second empty outlet and it reads 3.3 a third outlet thats empty and it reads 4.4.
I have no clue whats going on. is there another calibration that can be done?
I only have a Reef Octopus DC5500 return pump plugged into it. The pump is rated at 50 watts at full speed. .4-.45amps
The EB8 registers 2.2 amps
I have gone through the telnet power calibration and when all outlets are turned off they register 0 amps.
Another problem is when I start to turn on empty outlets one by one the amperage dray pulls 1 more amp.
So if I have on out on running the return pump the eb8 reads 2.2 then I turn on a second empty outlet and it reads 3.3 a third outlet thats empty and it reads 4.4.
I have no clue whats going on. is there another calibration that can be done?