Osmolator LED's question

[wddamf]

My Osmolator seems to be functioning correctly but the "Level" LED is never on. During steady state operation, the "Too High" LED is erratically flashing green (guessing the flashing is due to surface turbulence). When the pump kicks on, the "Level" and "Too High" LED's are steady yellow. Any idea what's going on?

Thanks,

Dan

[rvitko]

The flashing is normal on any osmolator made after Nov 2011, the green led will flash for 5 seconds, this indicates the water level is below the sensor and a delay is activated, if the water is still low after five seconds the yellow led and pump will come on.

The Too High LED is red, if you see only yellow, I suspect that the only yellow LED for pump on is showing through the two windows in the controller due to the viewing angle. The LEDs are almost 1/4" behind the windows so they can be viewed through the others depending on angle.