View Full Version : Ballast replaced on powermodule
jasimek
08/05/2014, 08:30 AM
I just replaced a dimmable ballast on my powermodule. I followed the instructions in the video. I got everything hooked up and the two bulbs that are on the ballast I replaced make a surging sound a flicker and don't turn on fully. Is this ballast bad or any suggestions?
jasimek
08/05/2014, 08:51 AM
Tripped the circuit breaker too
mcgyvr
08/05/2014, 09:58 AM
If you tripped the breaker you have a short.
Either the ballast is bad or you messed something up.
jasimek
08/05/2014, 06:23 PM
I'll check for a short in a wire
jasimek
08/05/2014, 06:39 PM
Any ideas on how to remove this ballast. It is in there very very tightly
vBulletin® v3.8.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.