hawaiifavo
10/13/2014, 09:20 PM
Hi, wondered if I could get some advise. I have bought two lengths of 4.5ft of Bosch Rexroth 20 (framing) - see attached images.
Mounting the LEDs to this railing system is easy you just use the existing screws supplied with the Radions or match them up and slide the screw heads into the rails. However I'm a bit stuck on actually attaching the rails to the canopy and then somehow getting the radions in there as well.
The roll top canopy is a shell with on the back of it open so there is no way for me to slide the rails into the canopy from the side. For more info on the roll top canopy see this link:
6.45:
http://www.mrsaltwatertank.com/mr-saltwater-tanks-ultimate-tank-overhaul-part-2/
Being able to slide the Radions is very important to me so any help would be greatly appreciated and apologies if I'm not being clear enough in what I am looking to achieve - I'm very tired.
Thanks
Mounting the LEDs to this railing system is easy you just use the existing screws supplied with the Radions or match them up and slide the screw heads into the rails. However I'm a bit stuck on actually attaching the rails to the canopy and then somehow getting the radions in there as well.
The roll top canopy is a shell with on the back of it open so there is no way for me to slide the rails into the canopy from the side. For more info on the roll top canopy see this link:
6.45:
http://www.mrsaltwatertank.com/mr-saltwater-tanks-ultimate-tank-overhaul-part-2/
Being able to slide the Radions is very important to me so any help would be greatly appreciated and apologies if I'm not being clear enough in what I am looking to achieve - I'm very tired.
Thanks