Mo2
04/30/2015, 05:08 PM
Originally bought this cube off CL. But ended up deciding on a Fluval M60 instead.
This tank has a chip in the bottom, front, left corner. It affects only the front panel. The glass is still there. The guy I bought it from said it has held water that way for the past 4 years. I water tested for 2 week and its fine. I did buy some DOW 795 I was going to seal it more just in case. Other small minor scratches as well. It'll have the stock return pump with it. The original owner also cut the over flow teeth off.
$80 tank and return pump.
If you want the sealant I can sell it at cost $15. Its unopened and unused. Will return to amazon if not needed.
Located close to DTLA
This tank has a chip in the bottom, front, left corner. It affects only the front panel. The glass is still there. The guy I bought it from said it has held water that way for the past 4 years. I water tested for 2 week and its fine. I did buy some DOW 795 I was going to seal it more just in case. Other small minor scratches as well. It'll have the stock return pump with it. The original owner also cut the over flow teeth off.
$80 tank and return pump.
If you want the sealant I can sell it at cost $15. Its unopened and unused. Will return to amazon if not needed.
Located close to DTLA