PDA

View Full Version : Gravity fed ATO -Eshopps


RussellHill
06/15/2015, 03:39 PM
I am getting back in the hobby after being away for about ten years. I ordered an Eshopps R-200 3rd generation refugium which I noticed has an ATO float valve installed on the return area. I will like to use it if possible. The water line in the return will be 5 inches. If I elevate the reservoir above the 5 inches but below the level of the refugium top will this stop a catastrophe should the float valve get stuck in the open position? Overflowing the sump upper edge in my living room cannot be allowed.

Any help really appreciated.

Jp_esp
06/15/2015, 04:43 PM
Had one in my previse set up and it works but need to set up correctly. This time I went with a JBJ ato and will say if your able to go with the JBJ or similar brand.

wildman926
06/15/2015, 08:14 PM
I have used these float valves for many years. If they stick, it is in the off position. Just be sure to clean them once in a while, and you will be good to go.

http://i150.photobucket.com/albums/s86/wildman926/Aquariums/Algae%20Turf%20Scrubbers/532D13E0-3967-4DD3-83EB-5708DEB34E21_zps2e7c93c0.jpg