PDA

View Full Version : RODI question


ryeguyy84
06/18/2015, 08:38 AM
HI RC, I replaced my RO membrane after 4 years because the TDS post RO went up to 6 and it is usually 4. the new membrane is the same model but my TDS is 8 now. i've made about 20 gallons of RO water and it seems like it's now bouncing between 7 and 8 TDS. is this normal or should I pull the membrane out and try to re-seat it in the housing?

SaltyMember
06/18/2015, 09:22 AM
Did you replace the rest of your filters also or just the RO membrane? Also I would also run more water through it and check again.

ryeguyy84
06/18/2015, 10:16 AM
Yes, I did a full swap and bleached everything while there was nothing in it. rinsed it well and added all the filters back in. I run 5 gallons through each filter when I put them in so nothing clogs up the next filter. i'll run it again tonight and see if anything changes.

SaltyMember
06/18/2015, 03:49 PM
If it still is running high after that then check to make sure the filters are seated properly in case something is getting bypassed. Good luck.

azjohnny
06/18/2015, 04:40 PM
What is your incoming TDS?

What is your incoming water pressure?

ryeguyy84
06/18/2015, 05:44 PM
Incoming tds is 180-200. 183 currently with 8tds post membrane.

70psi

ryeguyy84
06/18/2015, 05:48 PM
I should add its a Dow filmtec 75gpd membrane.

http://www.bulkreefsupply.com/75-gpd-reverse-osmosis-membrane-dow-filmtec.html