deputydog95
06/21/2015, 01:29 PM
I bought two new MP10W's last March at my LFS. Manuf in 2014 I think. No problems. Plugged them in, followed the directions, master and slave went to work.
I recently picked us a used MP10W at my LFS. Manuf in 2011.
I tried no less than a dozen times and I can't get it to go into slave mode with the other two units.
I followed the directions explicitly that are online, but it doesn't react the same way my 2014 units do when pressing the sequence of buttons.
I tried to update the firmware by getting into go into update with one of my newer units, but it won't cooperate.
What am I doing wrong here???
I recently picked us a used MP10W at my LFS. Manuf in 2011.
I tried no less than a dozen times and I can't get it to go into slave mode with the other two units.
I followed the directions explicitly that are online, but it doesn't react the same way my 2014 units do when pressing the sequence of buttons.
I tried to update the firmware by getting into go into update with one of my newer units, but it won't cooperate.
What am I doing wrong here???