PDA

View Full Version : location Location Location


shellsea
07/13/2015, 02:52 PM
Nope, I'm not buying real estate but I did buy the following
Pressure Gauge Kit w/ 1/4in push fittings PGK-4 1 $14.99 $14.99
CSPDI System Cartridge Replacement Kit, Standard Twist-On Cap FK-CSPDI 1 $45.97 $45.97
0.5 Micron Carbon Block Filter 10-inch CF-0.5-10 1 $13.99 $13.99
SpectraSelect PlusC 90-GPD RO 99 Percent Rejection Membrane MEM-SP-0090 1 $54.99 $54.99
Flow Restrictor - Standard - 90-GPD FR-90 1 $5.99 $5.99


I have not installed any of the above yet because my old filters were rocking along and tds readings were zero but it is now time to change. Cartridge and membrane replacement is a no brainer but where do I install the pressure gauge to get the most benefit? What about the flow restrictor? Have not found that that info among all the good info on your forum here or web site. Can you point me to it?
Thanks
jack
Destin, Fl.

shellsea
07/13/2015, 03:01 PM
Cancel the pressure gauge question. I just found that info on your manuals page. Still searching for flow restrictor install directions though.

SpectraPure
07/13/2015, 03:12 PM
If your system is working well, there's no need to change the flow restrictor.

Scott at SpectraPure

shellsea
07/13/2015, 03:22 PM
This is a competitors system that I am changing out to use your membranes and filter cartridges. I am not sure if there even is a flow restrictor but if I find one (right in line before the membrane???) I will replace with the 90 GPD restrictor I purchased with your 90 GPD 99% rejection membrane. I found directions for that install on one of your kit manuals.

SpectraPure
07/13/2015, 03:40 PM
There HAS to be a flow restrictor.

I hope you find it at the membrane end of the waste water line.

Scott