Marchillo
10/11/2015, 01:19 PM
I've had one of these setup for a year. Upgrading one pump to an MP10.
I'm not sure if I have the Tetra brand or the Aqueon Brand. I measured the glass on the corner and appears to be 1/4". According to the instructions I can install this pump without the rubber spacer.
Anyone have this setup? I'm assuming it will be fine but wanted to check.
Thanks - Steve
I'm not sure if I have the Tetra brand or the Aqueon Brand. I measured the glass on the corner and appears to be 1/4". According to the instructions I can install this pump without the rubber spacer.
Anyone have this setup? I'm assuming it will be fine but wanted to check.
Thanks - Steve