PDA

View Full Version : Problem with new UPLC 2


GQuinn
12/02/2015, 05:54 PM
I hooked up my new UPLC 2 and when the pump kicked on for apps 15 seconds then shut off. Now the yellow LED is flashing (run/low) and nothing is happening. The water level in the sump is above the 2 inch mark on the tube.

SpectraPure
12/03/2015, 02:33 PM
Does anything happen when you pull the tube up, or push the tub down?

Jeremy

GQuinn
12/03/2015, 03:25 PM
It seems to be cycling on and off as required, but the yellow light constantly flashes until you make the float switch. Once you release the float it starts flashing again. Maybe the flashing yellow light is normal?

SpectraPure
12/03/2015, 03:31 PM
ON page 5 of the manual:

CONTROLS:
Green LED: The Green “PUMP” LED will be lit when the pump is running
Red LED: The Red “RUN” LED blinks once per second to indicate
proper module operation.
“UP” Push-Button: Sets high set point and increases “ON-time” %.
“DOWN” Push-Button: Sets low set point and decreases “ON-time” %.

(The red LED has been changed to yellow).

GQuinn
12/03/2015, 09:17 PM
Thanks the color thru me off.

SpectraPure
12/04/2015, 04:02 PM
You are welcome!