JMorris271
11/07/2016, 10:49 AM
I had posed some questions in another thread earlier and I wanted to ask a few more since I have done what was suggested
I am getting a very thick layer of skim mate inside the neck, the cap is saturated and on top of the cone just before the neck about 2 inches or so. I cannot get higher than this so the skim will spill over into the cup.
Here are some shots of what I have going on.
361210
I am usually just seeing this foam. It is sort of erratic. I had just cleaned the body so thats why there is nothing on the top of the cone
361212
361211
What can I do to get this crapola to spill in the cup. If I crack the valve I get the swell of water.
Thanks again
I am getting a very thick layer of skim mate inside the neck, the cap is saturated and on top of the cone just before the neck about 2 inches or so. I cannot get higher than this so the skim will spill over into the cup.
Here are some shots of what I have going on.
361210
I am usually just seeing this foam. It is sort of erratic. I had just cleaned the body so thats why there is nothing on the top of the cone
361212
361211
What can I do to get this crapola to spill in the cup. If I crack the valve I get the swell of water.
Thanks again