MP40w blinking red

[dave540]

The power supply to my MP40w got wet and stopped working. My wet side was in bad shape as well so I ordered a new wet side along with a new power supply. Now my issue is that the driver only blinks red. I tried holding down the mode button until it flashes white and following the rest of the steps to get it working again but it won't stop blinking red. I tried unplugging and plugging in again with no results. I'm at a loss here. The driver never got wet just the power supply and had been working flawlessly before. Any help would be appreciated.

[Alex Y EcoTech]

Dave,

It sounds as though you may have purchased or been sent the incorrect power supply. I would recommend comparing the new power supply with your damaged one to see if you received the same model.

[dave540]

I think your right. Just checked and I have a 36v power supply instead of a 24v. Thank you. Now I get to go through the whole return process.


Would there be any chance that I may have damaged my driver or pump motor by plugging the 36v power supply to them?