PDA

View Full Version : Is this a crack in the pump


aumoenoav
04/10/2017, 01:51 PM
Is this a crack in the pump, or does everyone got this line going on the head of the pump? (It feels a tad deep).

Member No. 1
04/11/2017, 03:08 AM
What you see is the "mold" parting line. This is where the two halves of the injection mold come together during the manufacturing process. This is typical with anything that produced by injection molding. Some are bigger than others. Look closely at any plastic part, you will see this.
So nothing to worry about.