PDA

View Full Version : 6040 controller


reefkeeper2
04/27/2017, 08:49 PM
I bought a nanostream 6040 last June and the controller stopped functioning. Lights blink uncontrollably and the pump stopped running. Where can I get a replacement?

Thanks

rvitko
04/28/2017, 08:25 AM
Have you tried just disassembling and cleaning the pump? The controller will blink if there is an overload from a bad pump or jammed pump or failing power supply. That makes it difficult to diagnose where the issue is without getting it back to test.

reefkeeper2
04/28/2017, 09:18 AM
Yes, I have cleaned the pump thoroughly. I'll try switching power supplies.

reefkeeper2
08/24/2017, 06:02 PM
Roger, how do I order a new power supply? The problem comes and goes. It works for a few weeks then stops.

rvitko
08/28/2017, 09:00 AM
Did you find something with the power supply like water damage? I would not be so sure it is the power supply, usually this will be the motor or controller and the power supply is only shutting down from an overload. I would send it in for repair, my apologies for the late reply I was at MACNA. Just include a note with return address and phone number.

Tunze USA
305 Victor St
Austin, TX 78753

reefkeeper2
08/28/2017, 09:20 PM
Will do Roger, thanks.