replacement magnets and clips for 6095

[adtravels]

Hi,
I have some 6095's that have a couple of years use on them, I have recently replaced the propellers but the nose is still an issue and it may be the clips rattling a little.

please could you quote the replacement codes for current 6095 clips and magnets so I don't make a mistake when ordering?

Thanks

[Breadman03]

I found that vibrations were traveling up the power cord of my 6095's and causing them to rattle juuuust enough to be noisy. A little bit of adjusting the angle had them back to being quiet. I figure I'd mention it in case you hadn't checked it yet.

[rvitko]

Since mid 2015 the magnets are 6025.515 and clamp 6025.630 with silicon mounts 6020.620. I am inclined to think it is not the clamps or magnets and may be what Breadman03 said or possibly a loose metal shaft in the pump or worn disk 6055.740. The clamps are rarely the cause unless the isolators between the magnet and glass are damaged or missing or the silicon legs between the clamp and magnet are missing or pushed in to far.

[adtravels]

Thanks for all feedback, I will do an overhaul at the weekend and check for a wobbly shaft!!!