View Full Version : FMM rogramming for ATO

05/18/2017, 05:57 PM
Hi All:

I'm looking for the proper coding for the FMM module to manage refilling my ATO. I have the level sensors and solenoid attached to my FMM. For the moment, all I want to do is the open the solenoid when the low level sensor is triggered and close the solenoid when the high level sensor is triggered. Any help or a point in the right direction would be appreciated.

05/18/2017, 07:25 PM
Easily done using the new 'Tasks' function.

It's in the main Fusion Menu. Under the Configuration section


I'm not sure it will pop up for you but use the ATK task.

It will run you through the setup.

Sent from my iPhone using Tapatalk